If you have Mac OS HIgh Sierra or newer and you can't see your new drive, check this first.................
Please follow the steps below.
Step 1. Select the “View”
Step 1. Select the “View”
Step 2. Click “Show All Devices”
Step 3. Select the Destination drive you are going to erase
Step 4. After clicking “Erase”button, change the setting in Scheme from Master Boot Record to GUID Partition Map
Step 5. Then click erase button.
Related Articles
Fix to apply when Mac OS 10.13 was not installed prior new NVME SSD installation
For a new NVME SSD to be recognised* by an Apple machine, Mac OS 10.13** or newer would need to be installed before the new NVME SSD is installed. However, if your original SSD suddenly stopped working and you didn't already have Mac OS 10.13 or ...My new SSD for Mac is not visible in disk utility when accessed via Internet recovery partitions.
OWC Aura Pro X2 SSD or any other 3rd party SSD may come with no macOS installed. Therefore, when you install it, Mac will start and display a folder with a question mark because the computer has nothing to boot from. You need to boot into Internet ...SSD & RAM Installation Videos - Mac Pro (Early 2008)
Mac Pro (Early 2008) Hard Drive and Memory Install Video OWC's step-by-step video of how to install memory in the Apple Mac Pro (Early 2008). Duration: 4:01 Model ID: MacPro3,1How to correctly install your new Apple NVME SSD into a MacBookPro or MacBookAir
How to correctly install your new Apple NVME SSD into a MacBookPro or MacBookAir When installing the SSD, position the SSD at approximately a 25 degree angle towards SSD slot. (Picture 1) Then flatten it down - note SSD is still not fully in its slot ...How to format your new Apple NVME SSD to APFS
How to format your new Apple NVME SSD to APFS First install your SSD, we have an article all about this here Once you have it installed, boot up your Mac and immediately hold Command (⌘)-R until you are presented to recovery mode. Once there, go to ...